2015 Isuzu I-280,I290,I-350, Chevrolet Colorado, GMC Canyon Pickup, Silverado

2015 Isuzu I-280, I290,I-350
2015 Chevrolet Colorado
2015 GMC Canyon Pickup, Silverado

Locate the BCM as follows:

  1. Disconnect all electrical connectors.
  2. Press on the tabs to release the body control module from the bracket.
  3. Ensure the ignition switch is in the OFF position. Remove the right front hinge pillar trim panel

We need connector x1 and x3


X3 PLUG

X1 PLUG

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):

Open the NEWROCKIES PRO Module’s cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

Set the switches as in the photo here below:

Connect as following:

PRO Module
CAR Wires
RED
Splice into wire at VIOLET / YELLOW the BCM Connector x3 Pin 5
WHT
Splice into the VIOLET / BLACK wire at BCM connector X3 Pin 6
BLK
Splice black wire into BLACK with WHITE stripe wire at the BCM connector X1 Pin 1.
PPL
Not Used
GRN
Not Used
YEL
Splice into the WHITE / BLACK wire at BCM connector x3 pin 22
BRN
Cut WHITE with VIOLET stripe wire at the BCM connector x3 Pin 15 a couple inches from connector so you have room to connect the brown wire to the wire coming from the connector

Troubleshooting

Is the GM Security System (VATS, Passkey or Passlock) giving you problems?

Would you like to solve the problem permanently...

You are in the right place!

NEWROCKIES is #1 in the world. It was born to solve GM VATS System problems once and for all and it’s the only thing we do. Our PRO Module is a FULL VATS Bypass that gets rid of the system entirely, the Key part, the Lock part and the TDM (which is the brain of the system).