2007-2010 Pontiac Torrent, Chevrolet Equinox, 2008 Saturn Vue , 2007 – 2011 GMC Acadia and Traverse, 2007-2010 Saturn Outlook
The factory security functions are managed by the Body Control Module (BCM) where we need to make the connections. The BCM is located behind the radio. Starting at the bottom, pull to disengage the trim bezel clips. Disconnect the electrical connectors from the center trim bezel Remove the Radio. We need connector C1 Light green 27 […]
2005-2011 Chevrolet Malibu, Saturn Aura & Pontiac G6
Locate the BCM Remove the right console trim panel The BCM is located behind this cover we just need access to the plugs We need 2 plugs to connect the pro bypass the pictures below give the pin numbers of the plugs Plug C2 Grey Plug C4 Grey
2003-2007 Saturn Ion
The Connections are all made on a single connector at the Body Control Module, The BCM is in the center console, in front of the shifter on the lower side of the dash. Remove the trim. Apply the park brake. If equipped with an automatic or VTi transmission, shift the transmission into neutral. If equipped […]
2000-2005 Saturn L Series
Locate the BCM and install the PRO Full Bypass The BCM is mounted on the top of the glove box. There are 4 electrical connectors on the BCM. Body Control Module J2
2000-2002 Saturn SL SW SC Series
Locate the BCM and install the PRO Full Bypass The BCM is mounted on the top of the dash under the pad. 1. Disable the SIR system by taking the battery cables off. Notice: Be careful not to damage the VIN plate when removing or replacing the upper trim panel. Remove the instrument panel upper trim: […]
1996-1999 Saturn S Series
To install the pro bypass module we will need to access the RKE module behind the right rear side seat attached to the in-structure 1.1. Disengage seat cushion by pushing rearward, then upward at 2 front retaining locations to release the rear cushion from the retainer. 1.2. Slide the cushion from under the seat back […]
2002-2007 Saturn Vue
The factory security functions are managed by the Body Control Module (BCM) where we need to make the connections. The BCM is located behind the radio. Set the park brake. Move the shifter to the neutral position. Starting at the most forward end, pull up to remove the bezel. Disconnect the electrical connectors. Remove the […]
